Hi, Im trying to drive a DSI lcd with raspberry pi 5. The physical connectors on the board are labelled as CAM0/DISP0 and CAM1/DISP1.
When i tried vc4-generic dsi overlay the screen layout editor shows DSI as working but labelled it as either DSI 1 or DSI 2.
1. Just want to make sure if DSI-1 corresponds to CAM0/DISP0 connector and DSI-2 corresponds to CAM1/DISP1.
2. There is no pin 1 marking on the connectors. I hope pin no 1 is towards the board edge.
3. To make sure are those FPC connectors Bottom contact only?
When i tried vc4-generic dsi overlay the screen layout editor shows DSI as working but labelled it as either DSI 1 or DSI 2.
1. Just want to make sure if DSI-1 corresponds to CAM0/DISP0 connector and DSI-2 corresponds to CAM1/DISP1.
2. There is no pin 1 marking on the connectors. I hope pin no 1 is towards the board edge.
3. To make sure are those FPC connectors Bottom contact only?
Statistics: Posted by BalajiNarasimhan — Tue Jul 09, 2024 8:59 am