Hello, I have a Raspberry Pi Zero 2W and I attached the solderless hammer header to it. I also brought a big arcade button to attach to it but I'm not sure where to start with it
Presumably the connectors are https://thepihut.com/products/arcade-bu ... 25-10-pack
The exposed metal ends push on to the exposed metal lugs on the switch and LED. That's easy.
The little white JST connectors. Do they fit your newly-hammered 40-way header on your RPi board? There is a risk that the sides of the housing might foul adjacent pins and prevent them being pushed home. If they fit, that's easy too.
You will need to identify locations on the 40-way header where you have a Ground Pin directly adjacent to a GPIO pin.
This will help - https://pinout.xyz/
Some usable pairings are Pins 37/39; 34/36; 30/32. There are many others.
Statistics: Posted by B.Goode — Fri Jul 12, 2024 10:28 am