Leave the voltage as default 1.1V
From CMake:The last one is optional, you need to reinit UART after that if previously used (SPI as well).
After changing frequency, try this QMI timing:Try not to touch other QMI settings unless absolutely necessary.
The result:
From CMake:
Code:
PICO_EMBED_XIP_SETUP=1PICO_FLASH_SPI_RXDELAY=2PICO_FLASH_SPI_CLKDIV=2PICO_CLOCK_AJDUST_PERI_CLOCK_WITH_SYS_CLOCK=1After changing frequency, try this QMI timing:
Code:
qmi_hw->m[0].timing = 0x40000101;The result:
Code:
-------- StartPOWMAN VREG 0x000000b0 POWMAN VREG_CTRL 0x00008050 POWMAN VREG_STS 0x00000010 QMI M0_TIMING 0x40000202 QMI M1_TIMING 0x60007203 clk_ref 12.000000 MHzclk_sys 150.000000 MHzclk_peri 150.000000 MHzclk_usb 48.000000 MHzclk_adc 48.000000 MHzclk_hstx 150.000000 MHz-------- clock changedPOWMAN VREG 0x000000b0 POWMAN VREG_CTRL 0x00008050 POWMAN VREG_STS 0x00000010 QMI M0_TIMING 0x40000101 QMI M1_TIMING 0x60007203 clk_ref 12.000000 MHzclk_sys 133.000000 MHzclk_peri 133.000000 MHzclk_usb 48.000000 MHzclk_adc 48.000000 MHzclk_hstx 150.000000 MHz- Image may be NSFW.
Clik here to view.
Statistics: Posted by gmx — Tue Oct 08, 2024 12:02 am
