They provided the init sequence - but I don’t know where I should have that inserted.
‘Using a DSI Display’ documentation is very useful, and I am getting my head around with the further reading presentation suggested at the end of the document.
Just checking if I have all the necessary ingredients to make the panel work: is there anything else I need to know?
As for the pins connection between the host and the panel / driver IC, I suppose I can assign some pins from the RPi5’s GPIO (passing through the
Level shifter for the appropriate voltage)? And I can ‘tell’ the host which pins to pull when writing the driver software?
Many thanks for the advice, it’s been very helpful.
‘Using a DSI Display’ documentation is very useful, and I am getting my head around with the further reading presentation suggested at the end of the document.
Just checking if I have all the necessary ingredients to make the panel work: is there anything else I need to know?
As for the pins connection between the host and the panel / driver IC, I suppose I can assign some pins from the RPi5’s GPIO (passing through the
Level shifter for the appropriate voltage)? And I can ‘tell’ the host which pins to pull when writing the driver software?
Many thanks for the advice, it’s been very helpful.
9C,A5,A5
FD,5A,5A
48,03
53,
51,00,00
35
11
delay120ms
51,0D,BB
9F,0F
CE,22
29
Statistics: Posted by csvke — Wed Nov 06, 2024 7:56 am