Yes, and I have tried all possible combinations. I know the USB2 signals are connected correctly because the port works in USB2 mode.
If the RX and TX pairs are swapped the memory stick does not show up on the port.
There is a note in the documentation that says the P/N can be swapped. If I swap the P/N signals I get the same results.
I was just wondering is anyone has gotten the USB3 to work on the CM4 I/O board.
If the RX and TX pairs are swapped the memory stick does not show up on the port.
There is a note in the documentation that says the P/N can be swapped. If I swap the P/N signals I get the same results.
I was just wondering is anyone has gotten the USB3 to work on the CM4 I/O board.
Statistics: Posted by 4plus12labs — Tue Dec 17, 2024 6:41 pm
