Camera board • Re: Pan/tilt dual GS camera holder

Planned was to use soldering iron to add threaded inserts left and right, and then 3Dprint the outer holder.
Just as a quick test I mounted on a tripod, and that was stable.
So this solution is good enough for me currently.
I always have the option to go with threaded inserts later if needed.

I did 3Dprint outer camera stand:
https://www.printables.com/model/790362 ... oldermountView from back, with first outer stand that was 10.2mm too wide and needed adapter rings ...

This screenshot shows 688x136 views from both cameras of wall 75cm distant:


It confirms that both lenses are 4mm (same size).
But despite camera sensors in same plane and at same height and parallel, the lenses make a difference vertically.
Likely I need to buy two identical (CS) lenses for high framerate stereo vision ...

I did buy two 6mm lenses, and they arrived today.
These are my first "Raspberry" lenses, I had lenses from other vendors, most from Arducam.

The scaled to 50% size screenshot left and right terminals show nicely that now both inch number lines are parallel together.
Unfortunately the two terminal windows are on different vertical height (less different than the two previous lenses).
So despite same GS cameras with same sensor, parallel same height mount, and same lenses the height of FoV is different?!?!?

Statistics: Posted by HermannSW — Thu Mar 07, 2024 3:28 pm

---